200V11103-0002 Fuel Control Valve for Selected Diesel Applications

200V11103-0002 fuel control valve for Selected Diesel Applications

The 200V11103-0002 fuel control valve is supplied under the Rayfuel product brand as an aftermarket replacement for selected diesel applications. This listing was prepared from the complete OE reference and the application information supplied in the product catalog. It is intended for diesel repair shops, fuel-system specialists, distributors and vehicle or equipment owners who have verified the number on the removed valve.

Rayfuel is the product brand for this page. Vehicle, engine and fuel-system names identify application references only. The item is not presented as a genuine boxed component from any vehicle or fuel-system manufacturer. Browse related parts in our diesel fuel metering valve range.

Product Identification

• OE / part number: 200V11103-0002
• Product type: Fuel Control Valve
• Application: Selected diesel applications
• Quantity: 1 valve
• Product brand: Rayfuel
• Condition: New aftermarket replacement

Use the complete number 200V11103-0002 as the primary purchasing reference. Numbers written with different spacing or punctuation can describe the same reference, while two valves with a similar body or connector may have different internal flow or pressure-control characteristics. Appearance alone is not sufficient for fitment confirmation.

Application and Fitment Checks

This valve is listed for selected diesel applications. Exact compatibility may still depend on the fuel-pump number, engine code, production date, power rating, emissions specification and regional configuration. Compare the OE number from the original part and, where available, confirm the pump or vehicle record before purchase.

Also compare the electrical connector, mounting flange or thread, sealing position, valve length and tip profile shown in the product image. If the old number cannot be read clearly, send photos of the complete component and its installation position for a manual comparison.

What This Valve Does

A diesel fuel control valve helps the fuel system regulate inlet quantity, pressure or pump delivery according to the design of the application. Stable valve operation supports reliable starting, controlled fuel pressure, smooth idle and consistent response under load. Final system performance also depends on clean fuel, unrestricted supply, correct sensor signals, sound wiring and the condition of the pump and injectors.

Common Symptoms Requiring Diagnosis

• Hard starting or extended cranking
• Unstable idle, hesitation or stalling
• Low, high or fluctuating fuel-pressure readings
• Reduced power under acceleration or load
• Fuel-pressure control or actuator fault codes
• Intermittent limp mode

These symptoms do not prove valve failure. Restricted filters, air in the supply line, contaminated fuel, wiring faults, pressure-sensor errors, injector leakage and internal pump wear can produce similar complaints. Test the fuel system and confirm the cause before replacement.

Installation Notes

Installation should be completed by a qualified diesel technician using clean working practices. Keep fuel connections capped until assembly, prevent debris from entering the pump, renew the specified seal and follow the correct tightening procedure. Do not force the valve into position. After installation, prime the system and check pressure behavior and leakage according to the service procedure for the application.

Before You Order

Please confirm OE number, pump number, application or old-part photos before ordering. Verify 200V11103-0002 and the complete component shape. For help with number and photo comparison, use the Rayfuel contact page.

The 200V11103-0002 fuel control valve should be selected by the full OE reference and verified application data, not only by vehicle name or visual similarity.