



095000-7780 Diesel Fuel Injector for Toyota Hilux Prado 1KD-FTV 3.0L
$83.90
- Part Number: 095000-7780
- Cross Reference: 23670-39316
- Application: Toyota Hilux / Land Cruiser Prado 1KD-FTV 3.0L Euro 4
- Type: Denso-System Common Rail Diesel Fuel Injector
Ask for Compatibility
Not sure this part fits your engine or vehicle? Send us your OE number, VIN, engine model or old part photo before ordering.
- OE number matching support
- VIN / engine model verification
- Old injector or pump photo accepted
- Usually reply within 12 hours
Send these details for a quicker fitment check.
100% tested before shipping
OE matching and warranty support
Worldwide delivery available
095000-7780 Denso diesel fuel injector for Toyota Hilux Prado 1KD-FTV
The 095000-7780 Denso diesel fuel injector is supplied by Rayfuel as an aftermarket replacement for selected Toyota Hilux and Land Cruiser Prado applications with the 1KD-FTV 3.0L Euro 4 diesel engine. It cross-references Toyota OE number 23670-39316 and is offered for part-number-matched diesel fuel-system repair. Repair workshops, wholesalers and parts distributors can find this item in our Denso common rail injector range.
095000-7780 Denso diesel fuel injector identification
- Primary part number: 095000-7780
- Toyota OE reference: 23670-39316
- Vehicle reference: Toyota Hilux / Land Cruiser Prado
- Engine reference: 1KD-FTV 3.0L Euro 4
- Product type: Common rail diesel fuel injector
- Product brand: Rayfuel
Use both 095000-7780 and 23670-39316 when comparing the replacement with the injector removed from the vehicle. The Denso wording on this page identifies the common rail system and the search reference used by buyers; it does not represent a claim that the supplied aftermarket replacement is a genuine Toyota or Denso boxed component. Accurate identification should be based on the stamped number and the complete vehicle information.
Application and fitment
This injector is listed for selected Toyota Hilux and Land Cruiser Prado vehicles fitted with the 1KD-FTV 3.0L Euro 4 diesel engine. Toyota applications can differ according to production year, market, emissions specification, vehicle code and injector calibration. An engine-family match alone does not guarantee that every 1KD-FTV version uses the same injector. Compare the electrical connector, fuel connection, nozzle end and all stamped references before installation.
Toyota owner documentation confirms that Hilux models were produced with the 1KD-FTV engine, but the manual or vehicle model name should not replace an OE-number check. If the old injector carries a different number, send clear photos and the vehicle identification details to Rayfuel before ordering.
Common rail injector function
A common rail injector controls the quantity and timing of pressurized diesel fuel delivered to the combustion chamber. Its operation affects starting, idle stability, combustion balance, smoke and engine response. The 095000-7780 Denso diesel fuel injector should be selected as part of a properly diagnosed repair rather than from symptoms alone. For general information about common rail diesel components, see the Denso diesel components reference.
Common signs an injector may need checking
- Hard starting or extended cranking
- Rough idle or uneven cylinder operation
- Reduced power under acceleration or load
- Excessive black, white or grey exhaust smoke
- Abnormal combustion noise
- Fuel leakage around the injector or sealing seat
- Injector-related diagnostic trouble codes
These symptoms can also result from fuel-pressure faults, wiring problems, poor compression, air-intake restrictions or other engine conditions. Return-flow measurement, electrical checks, scan-tool data and professional bench testing may be needed before replacement is approved.
Installation and calibration
Have the injector installed by a qualified diesel technician. Keep all high-pressure fuel connections clean, inspect the injector pipe and replace required sealing washers or related service parts. Use the correct tightening sequence and torque information for the specific Toyota application. Some configurations may require injector compensation or calibration data to be registered with compatible diagnostic equipment, while others may follow a different procedure. Confirm the applicable service process instead of assuming coding is always required.
Before you order
Please confirm OE number, engine model or old part photos before ordering. Check 095000-7780 and 23670-39316 directly against the existing injector, then confirm the vehicle model, 1KD-FTV engine, production year and market. For assistance, use the Rayfuel contact page to send the old part number, VIN details where available and clear photos of the injector body and connector.
The 095000-7780 Denso diesel fuel injector is intended for OE-number-matched aftermarket replacement in compatible Toyota diesel applications. Final fitment depends on the exact vehicle specification and old injector identification.
Rayfuel supply and support
Rayfuel supplies diesel injection parts for repair shops, wholesalers and distributors worldwide. Support includes number comparison, photo-based fitment checks, quantity quotations, mixed-parts inquiries and secure export packaging. Contact us before shipment if you need confirmation for multiple injectors or a particular Toyota market specification.
| Weight | 0.8 kg |
|---|---|
| Dimensions | 25 × 13 × 6 cm |








Reviews
There are no reviews yet.